Outdoor Living

Running a Natural Gas Line to Your Grill or Outdoor Kitchen

Underground gas line connected to residential home foundation by Puget Sound Gas

Most people decide to put their grill on natural gas the night the propane tank dies with burgers half done. If your house already has gas, there’s a better setup: a permanent line to the patio, so the grill never runs dry and nobody has to drive a tank to the exchange cage at the hardware store again.

It’s one of the more common outdoor jobs we do, and it’s usually straightforward. The questions that come up are almost always the same, though: can my current grill be converted, where can the grill go, and what if I want a full outdoor kitchen later? Here’s how we answer them.

Natural gas vs. propane for grilling

The big advantage of natural gas is that it doesn’t run out. It also usually costs less to run than propane, and there’s no tank to store, refill or haul around.

The trade-off is that a natural gas grill stays put. It connects to a gas outlet on the patio with a short hose, so you can roll it a few feet but you can’t take it camping or move it across the yard for a party. If you like to move your grill around, propane still has a place.

You’ll sometimes hear that propane grills cook hotter. Propane does carry more than twice the energy per cubic foot, but grills built for natural gas use larger burner orifices to make up for it. A grill designed for either fuel puts out the heat it’s rated for.

Can you convert a propane grill to natural gas?

Sometimes. It depends entirely on the grill.

Many grill makers sell a conversion kit for specific models. The kit swaps the burner orifices for larger natural gas ones and replaces the propane regulator and hose with a natural gas hose. On some grills, the valves get adjusted too. Done with the right kit, the grill works as well as one that came from the factory set up for natural gas.

Other brands don’t allow it. Weber, for example, says its grills are built for one fuel type, doesn’t support converting them, and treats changes to the gas system as voiding the warranty. In that case, the answer is to buy the natural gas version of the grill.

What you should never do is skip the kit and just connect a propane grill to a natural gas line with an adapter. Propane orifices are much smaller, so the grill will barely get warm. Going the other direction is worse: a natural gas grill hooked up to propane can produce flames far bigger than the grill was built for. Fuel and orifices have to match.

Before you plan around converting the grill you own, look up the model number and check whether the manufacturer offers a kit for it. If you’re not sure, send it to us and we’ll check.

Ready to stop swapping propane tanks?

Tell us where the grill sits and where your gas meter is. We’ll give you a free estimate for the line, the outlet and the hookup.

Quick-connect outlet or hard-piped?

There are two ways to connect a grill to the line, and which one you want depends on the kind of grill.

A freestanding grill on wheels usually connects to a quick-disconnect outlet mounted on the house or a post near the patio. The outlet has its own shutoff valve, and the fitting closes off the gas automatically when you unplug the hose. That lets you roll the grill away to clean the patio or tuck it under cover for the winter.

Use the hose that’s made for your grill and rated for natural gas and outdoor use, and don’t swap in a longer one to get more reach. Codes and grill manuals limit the length of that connector. If you need the grill farther from the house, the right fix is moving the outlet, not the hose.

A built-in grill set into an island gets hard-piped instead, with a shutoff valve you can reach without pulling the grill out. That’s the standard setup for outdoor kitchens.

Where the grill can go

Grill manuals set the clearances, and they vary a lot. Some call for 12 inches from combustible walls on the sides and back, and others call for 36. Check the manual for your model before you settle on a spot.

The overhead rule is the one that surprises people. Most manufacturers say not to put a grill under combustible overhead construction, like a wood patio cover or a low eave, unless there’s a vent hood rated to protect it. If you’re hoping to grill under the covered part of the deck when it rains, plan for that hood from the start.

Watch the siding too. Vinyl siding can warp from a grill parked too close, and it’s an expensive patch. Placing the gas outlet where the grill naturally ends up at the right distance helps keep it there.

Planning an outdoor kitchen

An outdoor kitchen is where gas planning really matters, because the load adds up fast. A built-in grill commonly runs 60,000 to 100,000 BTUs or more. A side burner adds another 10,000 to 15,000. A natural gas pizza oven, a couple of patio heaters or a fire pit can easily double the total. The line from the meter has to be sized for everything running at the same time.

A few things we coordinate with whoever is building the island:

  • The gas line needs to come up in the right spot before any concrete is poured or pavers go down, so we set the stub-up early.
  • Each appliance should have its own shutoff valve, reachable through an access door.
  • Enclosed islands need vent panels so any leaked gas can escape instead of collecting inside the cabinet. Grill makers require them for built-in installs.

If a fire pit is part of the plan, it can usually come off the same run. Our post on planning a natural gas fire pit covers the sizing and drainage details for that piece.

What it costs

A gas line to a patio grill typically costs $600 to $1,300. Where yours lands depends mostly on the distance from the meter and whether the line goes along the house or has to be trenched across the yard. A quick-connect outlet is a small part of that.

An outdoor kitchen with several appliances costs more, since it needs bigger pipe and more connections. A conversion kit, if your grill takes one, is a separate purchase from the manufacturer. The permit is extra in either case. For a full breakdown of what drives gas line pricing, see our guide to gas line installation cost in the Seattle area.

Put your grill on natural gas

We run the line, install the outlet or shutoff, pull the permit and connect the grill. Planning a full outdoor kitchen? We’ll size the line for everything you want out there.

We hook up grills, side burners, pizza ovens and patio heaters across King, Snohomish and Skagit counties. See the full list on our appliance hookups page.

Common questions

Do I need a permit to run gas to my grill?

Yes. Any new gas piping in Western Washington needs a permit and an inspection, including a line to the patio. We handle both.

Can I use an adapter to hook my propane grill to natural gas?

No. The orifices inside a propane grill are sized for propane, so an adapter alone leaves you with a grill that won’t get hot. It needs the manufacturer’s conversion kit, or you need a natural gas model.

How far can the grill be from the gas meter?

There’s no fixed limit. A longer run just needs larger pipe to deliver enough gas, so distance mainly affects the cost. We size the line based on the grill’s BTU rating and how far it has to go.

Can I add a gas outlet now and buy the grill later?

Yes, and it’s a common way to do it. We cap the outlet with a shutoff so it’s ready when you are. Let us know roughly what size grill you have in mind so the line can handle it.

Neal Markley, owner and master gas pipefitter at Puget Sound Gas

Written by the Puget Sound Gas team

Puget Sound Gas is a family-owned gas piping company in Sultan, WA, led by Master Gas Pipefitter Neal Markley. Our team brings 35+ years of combined experience installing and repairing gas lines for homes and businesses across King, Snohomish and Skagit counties.

Meet the team
Scroll to Top